Submit a Case Customer Portal Sign Out
Contact Neuralog
Contact Neuralabel
Skip to content
  • There are no suggestions because the search field is empty.

How to get started with the NT1000 Thermal Truck Printer.

Learn how to unbox, set up, and power on your NT1000 for the first time.

Steps:

  1. Unbox Carefully

    • Remove all packaging materials, including the blue protective tape inside the printer.

    • Keep the original packaging for future transport or shipping.

Video: Neuralog NT1000 Hardware Setup Video 

  1. Connect Power and Cables

    • Plug the power cord into the back of the NT1000.

    • Connect either a USB cable or a network cable depending on your setup.

  2. Install Printer in Rack

    • Secure the 3U chassis into your logging truck or rack-mounted system using the included rails.

  3. Power On

    • Turn on both the rear power switch and the front power button.

    • The green power light will illuminate, and the red light will blink twice repeatedly to indicate that paper needs to be loaded.

Tip: If the red light blinks three times, the top cover may be open. Close it until it snaps into place